Seems to work well..getting the colored bulb covers on is a little tricky..I like the way it lights up and its much easier to see at night then the old sunpros I had before.

I only bought it to get the 1.5 inch voltmeter, the oil and temperature gages can be bought separately but not the volt meter

Decent if your looking for a cheap set of gauges

No they were too small I went to my local O'Reillys and bought the big set just like them for less money

Very nice looking gauges. They have worked flawlessly. Look great in my old muscle car! Ran wires through existing holes in the firewall. Make sure they are protected from rubbing on metal. The plastic oil line works fine. I think it is less likely to be damaged/kinked than copper line. Just my opinion. It has lasted years for me. Just take the added precaution of shielding it where it runs by the hot engine. I used some cheap plastic wire shielding I bought from a local auto parts store. No problems. Used a Tee fitting at the oil pressure outlet on the engine block to supply both the oil pressure gauge and the low oil idiot light on my dash. My water temp probe fitted into an auxiliary water port on the water passage of my aftermarket eddy air gap intake with an adaptor I bought from my local Ace Hardware. Honestly, the most difficult part of this install was mounting the cluster bracket under my dash.