Drill America DWRRTPS2/0 #2/0 High Speed Steel Spiral Flute Taper Pin Reamer, DWR Series
Key features
- •High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
- •Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
- •Available in round shank with square end
- •When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging
- •0.1137-inches short end and 0.1462-inches large end
Drill America DWRRTPS2/0 #2/0 High Speed Steel Spiral Flute Taper Pin Reamer, DWR Series
List Price: $36.30$32.67DEALYou Save: $3.63 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 24, 2026In Stock (3)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers3.8
out of 5
Based on 3 reviews
5★
67%
4★
0%
3★
0%
2★
0%
1★
33%
Worked almost too well.
big daddy•February 10, 2017
This thing is so good at it's job that I nearly over bored my front sight base. Apply light even pressure and try fit your parts frequently, that is the advice I would give with this thing. It's slow to begin, but as it gets deeper it cuts very fast.
Easy to use
Robert M.•August 22, 2016
Good reamer for taper pinning something. The military has used taper pins for years to hold parts securely on a gun. Parts that get heat and vibration, parts your life depends on. Its an easy process with this tool, you pre drill a smaller hole (That you can find on the internet), and you put this in a tap holder and rotate with a small amount of pressure. It goes slowly so you can check depth with the pin as you go.
One Star
Edward P. Jordan•December 9, 2015
very brittle shattered on first hole
