Drill America 1-3/16"-16 High Speed Steel Plug Hand Tap, DWT Series
Key features
- •High-speed steel tools are good for most general purpose applications, offering a combination of hardness and toughness for wear resistance
- •Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
- •Round shank with square end
- •Straight flute tools allow chips to collect in the flutes as they cut and are well suited for most applications in shallow cuts
- •Right-hand cut tools have a cutting action that engages when they are run in a clockwise direction
Drill America 1-3/16"-16 High Speed Steel Plug Hand Tap, DWT Series
List Price: $101.84$91.66DEALYou Save: $10.18 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 23, 2026In Stock (2)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers4.4
out of 5
Based on 10 reviews
5★
40%
4★
40%
3★
0%
2★
10%
1★
10%
good for a project that doesn't need high quality , high dollar tools
old grumpy✓ Verified Purchase•July 29, 2017
This a Bottoming tap, not a taper thats pictured.
Nice cheap tap not labeled where made Marked HSS , size marking a little small, comes in plastic box to protect the cutting edges , I am using it for aluminum so it will be perfect for my application , teeth cut sharp , decent rake and relief grinds are decent but not polished . not a bad price for the size and application .
Nice cheap tap not labeled where made Marked HSS , size marking a little small, comes in plastic box to protect the cutting edges , I am using it for aluminum so it will be perfect for my application , teeth cut sharp , decent rake and relief grinds are decent but not polished . not a bad price for the size and application .
good stuff
russ riedel✓ Verified Purchase•June 9, 2017
This tap cuts good clean thread. Holds up to 4150 tool steel, stays consistant.
For AN-12 threading
Jerry Robison✓ Verified Purchase•May 13, 2017
1-1/16 is used for AN-12 fittings.
Drill = 31/32 into aluminum.
HSS should stand up to mild steel.
This is one big tap, far outside the capability of my biggest T-wrench. Had to apply a 10 inch adjustable crescent.
Drill = 31/32 into aluminum.
HSS should stand up to mild steel.
This is one big tap, far outside the capability of my biggest T-wrench. Had to apply a 10 inch adjustable crescent.
Looks like good quality
Dave K✓ Verified Purchase•March 31, 2017
Looks like good quality. I have not actually cut any new threads with it, but I did use it to chase threads in special about 40 steel nuts. I spun it in and out with a drill. It worked like a champ at this task. Cleaned up the threads nicely and didn't chip or break. One star off only because I haven't actually cut a new thread yet and can't say how well it works, or how long it lasts under tougher jobs.
Worked fine bottoming out a blind hole in an E46 M3 ...
Ty✓ Verified Purchase•March 11, 2017
Seemed high quality enough for my job. Worked fine bottoming out a blind hole in an E46 M3 cast iron diff housing.
Page 1 of 2
