I agonized a bit about which stainless steel table to order, because I did not like what I saw in the reviews of any of the choices. It looks what is essentially the same table is sold under two or three brands. The one that was clearly different was the Seville, which looked flimsier and was also described by many of the reviewers as arriving with dents. I chose this one because it was clear that the shelf was attached with set screws (as is the top). Turns out it came with a couple extra set screws and the Allen wrench needed to close them, but in an odd place in the box and I did not find them until after I had already assembled the table with my own Allen wrench.

As others have described, dents were an issue. One side of the lower shelf was seriously dented and two of the other three were somewhat bent. They were clearly like this when the table was placed in the box at the factory, because the way it came boxed, basically with the shelf inside the top, which is much wider and longer than the shelf, there was no conceivable way it could have happened in transit. I was able to straighten out the two bent sides to where it was not noticeable and the dented side, luckily, is positioned in my laundry room so it is not visible. The top also had a mild dent or bend in one side. Although both the top and the shelf had coatings intended to protect them, those had been scratched and ripped in multiple places, resulting occasionally in some mild scratches to the metal underneath. You would think the workmen must have been tossing these around the factory at random, or perhaps the parts had been through some sort of natural or manmade disaster. It is hard to imagine how all this would have happened in a properly run factory.
It is also worth noting that one of the bolts holding the top of the table to the metal supporting the legs had simply broken off. It looked like a poor-quality weld was the cause. Luckily this was one of quite a few bolts and did not seem likely to cause any stability issues. (Hopefully the others won't just fall off over time!)

The only issue I had with the design is that the table legs are quite a bit smaller than the sockets in the top the fit into, so there is a lot of extra space on the sides where the set screws are tightened. This did not seem to be a problem, but one has to wonder why they would intentionally design it that way.

In spite of all this, I'm fine with the table. Since I am just using it in my basement laundry room, it does not need to look perfect. It looks good enough, and does seem sturdy.

I will admit that I was a little hesitant when my husband wanted to order this product. My opinion has completely changed. I absolutely love having this table in my kitchen. You can set hot pans and dishes on it without having to worry that you're burning the counter. It's also great for baking when you need to roll out dough. Would definitely order again if I get a bigger kitchen!

Came scratched, and spot welds showing on the table too. One spot weld was broke off in the box. Table looks built decent but many flaws and scratches all over the top.

It was initially delivered to the wrong address, so it caused some problems.
But it works as intended, Happy with it.

Very sturdy and well built. This is my second table and these tables are of the best quality. No complaints whatsoever. Both received undamaged. Easy to assemble. It takes longer to remove the protective film covering the tables than assembly.