US Merchant Thermocouple 2304885 Dyna Glo 40-150K btu LP 1130/1474 by Fixitshop
Key features
- •T
- •h
- •e
- •r
- •m
- •o
BrandFixitshop
CategoryHeaters & Accessories
US Merchant Thermocouple 2304885 Dyna Glo 40-150K btu LP 1130/1474 by Fixitshop
List Price: $15.50$13.95DEALYou Save: $1.55 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 23, 2026In Stock (3)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers4.5
out of 5
Based on 10 reviews
5★
70%
4★
30%
3★
0%
2★
0%
1★
0%
Lead too short
Kiz✓ Verified Purchase•September 24, 2023
Was hoping this would solve my problem with the valve not staying open once the bypass button was released, it didn't and that's no fault of the thermocouple. They could have put a longer lead on it, it was 6" too short. Arrived exactly when promised.
Wire lead is too short. Spliced new wire. Heater fired up.
dw✓ Verified Purchase•August 14, 2023
Wire lead is too short. Spliced new wire. Heater fired up. It works.
Perfect
Amazon Customer✓ Verified Purchase•July 24, 2023
My Dyna Glo Pro propane heater would light but it wouldn't stay lit if i turned the knob past "ignite". I bought a thermocouple & installed it & it now works perfectly. Getting the heater apart was a but challenging but not impossible. Great find!
Works well. East install.
WizardOfGonad✓ Verified Purchase•July 5, 2023
Works good. Easy installation on my dynaGlo 60,000 btu propane heater. Remove 16 screws (including the hold down clip). Remove rear cover and fan assembly. Cut 2 cable ties. Remove three wires from terminals (white, blue and yellow (the yellow is the wire to this part) in my case). Remove the copper colored wire (ring terminal/Phillips head screw, which is the 2nd wire on new part). I removed the hold down that came with new thermocouple and replaced with the old one. Reassemble making sure wires are clear of fan. Allow 10 seconds or so to warm up on the first firing. About 10-15 mins.
Good thermocouple
Caca ✓ Verified Purchase•June 26, 2023
Remove old thermocouple, place this thermocouple in as the old one was in, move thermocouple to where pilot light stays on it at all times. Ng and LP thermocouple is the same. Note: Pilot fire must burn the tip of the thermocouple. it takes about 10 minutes.
Page 1 of 2
