Price was great and product went on easy. Cut the corners like you would wood trim with a beval. Time will tell of it lasts but the product seems like good quality and looks nice. Take your time when installing.

Don't expect great results out of the box. You will need to do some easy prep work!

A few days ago the outside temperature in my city was 13 degrees! I took a reading of the draft that was coming in through the gap by the floor and I got 46 degrees. The overall temperature in this room was 64 degrees while the rest of my unit was a toasty 81. Big difference.
I purchased this product to seal the gap between my hardwood floor and baseboard and hopefully put a stop to the unbearably cold drafts.

These are the steps I took to install this product accurately:

1) I scraped off all bits of paint or debris that was clinging to the surface I was going to cover.
2) I vacuumed the perimeter of the surface really well.
3) I made a solution of warm water and Dawn dishwashing liquid (Dawn cuts grease) and wiped down the entire surface area with this solution, using a sponge.
4) I then wiped down the surface with a clean towel.
5) I soaked another towel in clean water and cleaned off all soapy residue.
6) I used a clean, dry towel to wiped down the surface and to absorb any excess moisture.
7) I used my hair dryer in its highest hot setting and air dried the entire surface.
8) I left it alone overnight.
9) Next day I started my installation from a corner. I cut the strip at a 45 degree angle as per instructions (it actually took me a couple of tries to get it right) and I started to install the strip.
10) I dabbed a little bit of Gorilla glue (with a toothpick) at the corner for extra adhesion and began to lay out the strip, carefully pressed it into position and went over it 3 or 4 times with my thumb to set it in well and then I would do the next portion. (Helpful Hint: remove the plastic backing in stages, about 8 inches or so of backing at a time, apply and repeat.)
11) When I finished one entire wall, I went back to the corner and started the other wall. Here it got a little bit tricky to make as much of a seamless connection as possible at the corner. I ended up CAREFULLY removing the putty from about 1/2 inch of the strip WITHOUT CUTTING the vinyl. (You can do it, just take your time!) Then I kept placing it at the corner to see how it looked and , with a pair of scissors, kept trimming the vinyl until it aligned perfectly in the corner. Here, again, I applied a bit of glue to make sure I had great adhesion and finished the other wall.
12) My walls are longer than the length of the strip so I had do a connection at a couple of spots. Easy enough, I just made sure that the connection would be hidden behind the furniture in the room.

I am writing this review in the room I just finished. The temperature outside today is 29 degrees, the floor area is registering 69 degrees and the temperature in this room right now is 80 degrees! It is finally comfortable to be in here. The only difference now? That strip I so carefully installed.

Bottom line: Yes, this strip will make a big difference but it depends on what surface. With wood to wood installation it appears to work like a charm. Additionally, I installed the strip on the floor area. If I needed to apply this to a ceiling or vertical wall area, I would take an added step of applying dabs of glue at intervals (every foot or so) to ensure better adhesion. I cannot speak for its application on other surfaces.

They delivered on time. Look good, but haven't used it yet

This product is great for covering small gaps between parquet flooring and existing molding. The tape has a nice design that blended with the original design Where gap was too large, it was hard to apply. Wish it came with a small applicator tool.

Worked exactly how it was described to do.