As the header says, I mounted these directly on a "popcorn" plaster wall and they're doing great several months later. The adhesive tape is good quality, and the plastic on the mounts seems to be fairly thick and strong. Simple and effective product that I recommend.

If you're mounting these on a wall like mine, here's what I recommend: locate where you want them mounted, clean the mounting point on the wall with rubbing alcohol and a lint-free rag (be careful - this can possibly fade or eat away at paint if you aren't careful), press and hold the mount against the wall for 30 seconds while the tape sets, and then do not disturb them for an hour or so.

Purchased these to mount sensors to my wall. they did exactly what i needed them too. Only downside is I accidentally attached them to the wall before calibrating my sensors and oculus wanted me to move them farther apart. I had to find new command strips to re-stick them to the wall. I'd find a way to temporarily place them on the wall during calibration so that you don't waste the command strip.

We can look around and have a better view. The rooms in the simulation look better and bigger with the sensors mounted 4 to 5 feel apart near the ceiling

So I have loved star treck bridge command and especially beat saber for my vr but my pet cat kept disrupting my games. The problems with having the vr sensors using their normal stands was how my desk would have to be clear and the cat could sit in front of them. I ended up having to have my SO patrol the room for the cat to keep him out of the way of the sensors which was no fun for me, her or our furry friend.

I looked up wall mounts for the sensors and these popped up for my two that oculus included and they came with adhesive!

The install was suuuper easy and they accommodate the cable as well as the adhesive is good as of right now (about two weeks) so we'll see how well it holds up.

Now I was slightly worried about the build being from a 3d printer but the quality and build is totally fine and doesn't feel cheap so that ended up losing no problems.

PROS:
-Inexpensive
-Well built
-Color matches sensors
-Included a coupon towards future purchases
-Easy to install
-Has room for the USB cable!

CONS:
-While not an issue now, the 3d printed material may not hold up to constant sunlight or abuse so if that applies to you take caution
-Adhesive Velcro combo could be a weak point in later months.
-Has no rgb? (Haha)

Since these have been up I feel my tracking is alot better and the cat can't terrorize me :)

These work exactly as described. The adhesive is strong -- I'm a little worried about removing it later, but hopefully it won't rip the paint off.

These are printed with a 3D printer, in case you didn't read the description -- it's clearly stated. I have a 3D printer, but I figured that this was easier because I'm new at 3D printing and needed these mounts right away.

It's a little pricey, but for the amount of work that goes into printing these, the price seems fair to the person who created them. My dad always says, "Never begrudge a person their profit." So, while these are pricey, realize that they take hours to print, then they have to pack them up and ship. So a 2-pack for this price is decent since you'll only likely be buying these once.

Great little tool for people without 3D printers or if you do have a 3D printer and don't want the hassle.