Works perfectly for my 2014 jgc

Although this worked... it was not marked RMT as in the picture, and it required 2 - so after tax was $63.+.
I think the ones that were 2 for $25. would have done the job just as well.
Be sure to use WD40 or similar before trying to loosen the old ones, so you don't break them off.
After taking the old ones off - carefully disconnect the hose connectors.
Screw the replacements in place, lightly tighten them - after all they are made of copper.
THEN reconnect the hoses.
I got "service air ride suspension error briefly after starting the jeep, then again when I raised it to full height (off road 2), but no alarms since, and so far each morning the front end is still at height I left it previous night. - saved $3,000. dealer repair cost!

I waited 4 days after replacing the 2 elbow pieces to write this review, to make sure it healed the air in the shocks. Simple installation and fixed the problem of my front end low every morning. Replace both of them to be safe.

My 2012 Jeep Grand Cherokee WK2 QL air suspension was sagging all the way down to the frame bumpers after an hour or two. Problem started a few years ago with right front, then progressed to both front. At first it sagged overnight, then progressed to a few hours. I tested with soapy water to confirm a slight leak prior to moving the old elbows. As soon as I touched either of the old elbow and/or hose, the air started hissing out. This RMT part, WK2-A210-ADFU - RMT Air Suspension Elbow Repair Kit, appears to have a different o-ring seal than the OEM's. Comparing the innards side-by-side, I determined I made the right choice purchasing replacement elbows vice trying to replace the seal. The OEM elbow does not appear serviceable . BTW, you need to order the whole air line from Jeep to replace these elbows. What a pain that would be to run a replacement air hose! These RMT elbows are a direct replacement perfect fit with the existing hose lines. Just uncIip the clip per youtube videos (extremely helpful) and connect to the new part. I ordered 2 and had them installed in less than 10 minutes. First make sure the front is fully down with all the air out prior to removal. No air leakage for over 2 days with Jeep sitting untouched. It's been helpful to use JScan with OBD II adapter to get the air suspension levels at each wheel. I am ecstatic these leaks have now been fixed. Next step is to get an estimate on a Nitrogen fill. Thanks RMT!

funciona sin problemas.. rapido despacho. confiable