AUTOSAVER88 Catalytic Converter Compatible with 2004-2006 Sienna FWD/Lexus RX330, 2004-2007 Highlander 3.3L | Driver Side | Direct-Fit (EPA Compliant)
Key features
- •AUTOSAVER88 direct-fit high flow catalytic converter is designed to meet even exceed OE quality and performance standards without sacrificing flow rate.
- •Features heavy-duty stainless steel construction, internal ceramic substrates and catalyst coating have been carefully engineered for maximum efficiency.
- •Bolt-on connection, flange to flange, direct installing to existing exhaust system without doing extra modification. (Item comes with mounting gasket and hardware).
- •Genuine EPA certification, every catalytic converter body is stamped with exclusive EPA number. Federal EPA standard catalytic converters are backed 5 years or 50,000 miles limited warranty.
- •Vehicle Fitment: Compatible for 2004-2006 Toyota Sienna FWD / Lexus RX330, 2004-2007 Toyota Highlander 3.3L Driver Side/ Bank 2, please check product description page below for more information.
AUTOSAVER88 Catalytic Converter Compatible with 2004-2006 Sienna FWD/Lexus RX330, 2004-2007 Highlander 3.3L | Driver Side | Direct-Fit (EPA Compliant)
List Price: $189.14$170.23DEALYou Save: $18.91 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 25, 2026In Stock (1)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers3.7
out of 5
Based on 10 reviews
5★
60%
4★
40%
3★
0%
2★
0%
1★
0%
Close to factory fit
James Edge✓ Verified Purchase•October 12, 2023
Clearance is a little tight to get a ratchet on the nuts compared to factory part. Need a ratchet wrench for install and a bit of patience. It fixed my codes and passed emissions testing! Worth the $$
Good stuff - fit perfectly but no mounts for heat shield
Kevin Chenoweth✓ Verified Purchase•September 13, 2023
Fit perfectly but no mounts for heat shield. I just used my angle grinder and cut the mount of the old manifold and then used my cheap flux core wielder to put it on this one. Biggest issue was getting off the O2 sensor from the old Manifold... Needed 10 min with a small handheld propane torch to get it off
Good quality
RIKKO BILLIONÉ✓ Verified Purchase•September 9, 2023
Looks good!!
everything good
Khalil✓ Verified Purchase•September 6, 2023
everything good except the gasket not that good
Worked like a charm. No more check engine, traction control etc.
Jacob Wallace✓ Verified Purchase•August 15, 2023
The only issue was it lacked the mounting holes for heat shroud. For the price I am not complaining. If you want it to look factory then you have to pay more... Because I knew it lacked the holes I was able to bend one of the shrouds to just take the manifold bolts out knowing I wouldn't reuse them so it save me time one a seized shroud bolt. You need the exhaust gasket where it bolts to the exhaust under the motor as it was not included. Without the shroud you'll notice the exhause it directly exposed to dropping something onto it from above. Be more cautious after the fact. Fixed all 3 dash lights that would not go away and car driver wayyyyyy better.
Page 1 of 2
