Key features

• •Material: The base and handle of the bending machine are made of S45C high carbon structural steel, which has higher strength and deformation resistance, and the bending center column is made of GCr15, which is specially designed to bear large loads with high abrasion resistance and high elasticity limit
• •Dimensions: Diameter of the two fixed pillars is 12mm, clearance between pillars and bearings is 10.8mm, handle length 340mm
• •Bendable materials: Wire, steel wire, steel (without longitudinal ribs) flat iron (internal rounded corner bending), the maximum bending gap of 8mm solid material
• •Non-bendable material: Hollow material, hollow material will produce inner diameter deformation
• •Simple operation: Use the provided screws to fix the bending bar tool on the workbench or tabletop, and then place the material between the two columns for bending
• •Scope of application: The maximum diameter of the bendable round steel 0.3 inches (8 mm) or 10 mm (3/8 inch) aluminum bar or copper core, repeatable bending of flat billet 180 °