Starrett Steel Center Punch with Round Shank and Knurled Finger Grip - Hardened and Tempered, 5" Length, 1/4" Diameter Tapered Point - 117E
Key features
- •Center punch with 5" length and 1/4" diameter tapered point makes a starter dimple to guide a drill bit
- •Hardened and tempered steel provides wear resistance and strength
- •Round shank is knurled for grip
Starrett Steel Center Punch with Round Shank and Knurled Finger Grip - Hardened and Tempered, 5" Length, 1/4" Diameter Tapered Point - 117E
List Price: $36.41$32.77DEALYou Save: $3.64 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 25, 2026In Stock (13)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers3.2
out of 5
Based on 10 reviews
5★
60%
4★
20%
3★
0%
2★
10%
1★
10%
Like it wasnt even case hardened
Mathew M.•April 11, 2017
point smashed flat on the first strike. Like it wasnt even case hardened. Very disappointing for a starret product.
Five Stars
Drdrbcat•September 1, 2016
Good punch, made in USA
Still Pointy after two years :)
Sal•June 22, 2016
Works well on 304 stainless steel. I've used it a few times a week for two years. Still has the point. I didn't like the smaller Starrett punches as much.
I think I got a dud
Two-Dogs Junior•May 19, 2016
This is the first time I've ever used anything with the Starrett name on it and not been impressed. I bought a center punch to mark out holes on 1/4" mild steel, but the first time I used it the tip flattened out like aluminum (literally three light/medium blows from a 32oz ball peen hammer... Not like I was wailing on it). I tried re-grinding it and had the same result the second time. So up side, I have a very stylish drift pin; down side, I still need a good center punch.
Used this effectively to loosen bolts on a couple of ...
paxpaz•August 15, 2014
Used this effectively to loosen bolts on a couple of cars. One bolt was hard to get to and still wouldn't budge after removing a bunch of stuff to give room to get in there. I spent a lot of time trying to get it, even with decent penetrating oil. This center punch ended up being the answer. The other was a huge mounting bolt on a control arm. Worked again. This is heavy, durable, and precise. If you use a center punch to loosen a fastener, you might consider replacing the fastener, which is normal..
Page 1 of 2
