any sound that's above 1k gets super loud

I first ordered 2 units and then added a 3rd because I was impressed with the quality construction and performance.

The units performed right out of the box. The power handling corresponded to specifications as did the low range for this series bank of tweeters, providing output at 3000Hz and above.

The range is listed as 4kHz to 27kHz with maximum/peak power input of 300W, intermittent. The continuous RMS power handling capacity is rated at 150W.

The carpeted construction is sturdy and pleasing to the eye and to touch. The "Quick Connect" speaker terminals are spring-loaded and sturdy and easily accept 14-gauge unshielded wire securely and reliably. I estimate that they will accommodate heavier gauge wire as well.

The 8Ω input impedance matched the output impedance of the amplifier in bridged, single-channel mode resulting in maximum acoustic power transfer.

They could be deployed in pairs, with each unit driven by separate amplifier output channels

There is a useful and informative Owner's Manual which can be downloaded from the PYLE web site where the product also can be registered. .

In addition to the PYLE PAHT4, the product line also includes the PAHT6 and the PAHT9.which also may meet your needs.

Bottom Line: These units perform as specified. The price over performance ratio is outstanding and unbeatable at twice the price. I am very satisfied and pleased with these quality units.

I love this.

For my home theater setup, I have a digital receiver feeding surround sound. What I found to my dismay was that when using it for Dolby Digital or DTS soundtracks, it cuts out all tone control. You cannot adjust bass or treble. It produces a flat response since all equalization is supposed to have been built into the soundtrack by the film makers. Flat response sounds...kinda flat. I've got good bass because I can control my subwoofer but the speech intelligibility wasn't cutting it and there was nothing within the system I could do about it. In desperation, it occurred to me that if I could increase the quantity of high frequencies by adding tweeters, the additional highs might give me the clarity I sought. I bought this tweeter array and set it on my center speaker and tapped off the center speaker. It worked like a charm and now we can hear every word from anywhere in the room. It has an internal crossover so you get a nice boost of highs while having all your other sound frequencies intact. Maybe not the most elegant way of achieving better clarity for audiophiles, but it was the only thing I could think of to do. It's a nice carpeted unit and for the price, how can you beat it?

Plays ok