Bearing 608ZZ Shielded 8x22x7 Miniature Ball Bearings(Pack of 10)
Key features
- •Item: Radial bearings 608ZZ (608Z)
- •Type: Metal shielded Deep groove ball bearings 608ZZ
- •Material: Carbon Steel
- •Closures: Metal Shields
- •Dimensions: 8*22*7 mm/Metric
BrandVXB
CategoryDeep-Groove Ball Bearings
Bearing 608ZZ Shielded 8x22x7 Miniature Ball Bearings(Pack of 10)
List Price: $29.06$26.15DEALYou Save: $2.91 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 23, 2026In Stock (3)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers3.9
out of 5
Based on 10 reviews
5★
50%
4★
10%
3★
20%
2★
20%
1★
0%
Two out of ten are garbage
wesley•July 3, 2017
Two of the 10 bearings I got are worthless.
One has a off center inner ring that rubs on the sheilding and the other had a dent on one side of the sheilding causing it to rub and slow down the bearings. These two are basically garbage however I don't need all ten I ordered for the project I'm doing because i thought some extras would be nice in case I broke one. But the extras came pre broke.
One has a off center inner ring that rubs on the sheilding and the other had a dent on one side of the sheilding causing it to rub and slow down the bearings. These two are basically garbage however I don't need all ten I ordered for the project I'm doing because i thought some extras would be nice in case I broke one. But the extras came pre broke.
These has been working out good, no play in the bearings yet
firejackal•April 29, 2017
These has been working out good, no play in the bearings yet.
I have used these so far for my 3D printer on the Z axis rod support, and for the bowden extruders.
I have used these so far for my 3D printer on the Z axis rod support, and for the bowden extruders.
Just what we needed
Cynthia K.•April 25, 2017
Purchased these to rehab our Webasto diesel fired hydronic heater in the RV. These bearings and a few other inexpensive parts was all we needed to get the system working again.
Great, but may get a few small faulty ones.
Gage Henry•March 20, 2017
Works great in my 3D-printed spinners! One or two of them wouldn't wear in, though. They just wouldn't maintain the same speed as the others did. Didn't bother me personally, because I need several bearings to go on the outside edges as counterweights.
You get what you pay for
G. Brush•March 11, 2017
Very cheap, and it's reflected in the quality. A great deal of both axial and radial play. They move roughly compared to good quality, precision bearings. Would be okay for light loads and low usage where precision and durability aren't key concerns.
Page 1 of 2
