InstallGear Universal Car Power Door Lock Actuator Kit 12-Volt Motor (4 Pack)
Key features
- •(4) Actuators
- •(4) 6.75" Mounting Straps
- •(4) 8.5" Connecting Rods
- •(8) Self Tapping Screws
- •Additional Pictured Hardware
InstallGear Universal Car Power Door Lock Actuator Kit 12-Volt Motor (4 Pack)
List Price: $34.90$31.41DEALYou Save: $3.49 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 22, 2026In Stock (1)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers4.4
out of 5
Based on 10 reviews
5★
80%
4★
20%
3★
0%
2★
0%
1★
0%
System works great, if it lasts the test of time it ...
Eric✓ Verified Purchase•August 1, 2017
Installed the kit in my 2003 extended cab Silverado. I am an auto mechanic and the kit took me about 2 hours to install from start to finish. System works great, if it lasts the test of time it will be well worth it. Even if it only lasts a year, at $30, it will still be worth it. Very simple installation. I would recommend soldering and heat shrinking the wires over using the connectors included in the kit.
Excellent value and plenty of force
sledderal1016✓ Verified Purchase•July 6, 2017
Install went great. Plenty of force and travel to operate the stiff door locks on my 2003 super duty crew cab. The key fob easily works from 50 yards away and there was just enough wire on each lead to reach all for doors without stretching or splicing. I'll follow up with detailed complaints if anything goes wrong but so far I think it was an excellent value.
Cheap and effective
Henry Woods✓ Verified Purchase•July 2, 2017
I bought a 2008 Chevy Impala without checking the door locks and after a few days I realized that the actuators were bad in all 4 door after replacing the relay, install was a bit time consuming if you need to change more than one clear your schedule especially if you don't know exactly what you're doing and know that you will need a drill to drill into the metal under the door panel, and you will need to remove some of the foam on a couple of panels but once installed they work NEAR flawlessly that's the reason for the 4 stars instead of the full 5 one of them got stuck after the install and I had to yank it back into the unlock position for it to work but since then so far so great.
TL;DR: Works great one of the actuators got stuck but after a good tug started working again flawlessly.
TL;DR: Works great one of the actuators got stuck but after a good tug started working again flawlessly.
It works like a charm
Doreen Blouin✓ Verified Purchase•June 9, 2017
Once I got into the project it went well. The learning curve went quickly. It works like a charm. Having completed the difficult part I was like a kid showing off the results. Now I have to complete the job and figure out the trunk parts to completely accomplish what I want to do. Thank You for doing your part to help me accomplish what I wanted to do. Roger B.
they are easy to wire the bracket bends east enough but be ...
Anthony C.✓ Verified Purchase•January 23, 2017
I purchased these for a keyless entry system, they are easy to wire the bracket bends east enough but be careful not to rebend It too much or it could break. The rod cuts and holds good amd with some thread locker it will stay in place.I used epoxy to hold the connector in place and on a daily driver it's still holding.
Page 1 of 2
