A little larger than the usual ones but better to have too much than too little. And for the same price as the auto parts store, you get 10 instead of 2!

I purchased these hose clamps to reinforce some connections on my raised bed vegetable garden drip irrigation system.
The clamps look very well made with quality materials. The screw mechanism is sturdy and can be turned with a nut driver as well as with a screwdriver. This makes installation easier.
While the bands were slightly narrower than I expected, they will still work quite well for my intended application.

As described. Fast delivery

This fairly review applies only to SAE 10 clamps. I have these Koehler brand clamps in several sizes. The SAE 10 that I recently purchased are working fine but have a shorter worm drive housing compared to the higher end Ideal / Ideal - Tridon clamps. In general, the biggest difference between this brand and the Ideal clamps is in the worm drive housing. It's a little bit more robust in the Ideal clamps. The metal type used in the housing and screw also appears to be different. I don't think the Koehler clamps use SS for the housing or screw. Regardless, I haven't had any issues with these clamps in this size or any other and I look for this brand if I'm looking to purchase several to have on hand as, in my experience, they are better than some of the off-brand clamps that I have come across. But it is notable that the SAE 10 clamps have a shorter worm drive housing which logically translates to the possibility of a shorter worm drive gear and therefore, potentially, less secure clamping than the Ideal or other more highly regarded brands. In the other sizes of clamps that I have in this Koehler brand, the worm drive housings are about the same length as those of the Ideal / Ideal-Tridon clamps that I have. Again, I did not have any issues with these clamps in terms of performance however, for peace of mind if for nothing else, I did replace this SAE 10 size Koehler clamp with an Ideal brand clamp in one, very critical application.

Purchase on Dec 26, 2021
Installed on Dec 29, 2021

For: 2005 Hyundai XG350L
Issue: Coolant Leaking From Hose at Old Clamp

Symptom: I had a noticeable leak at my radiator hose connection, near the original clamp. Parking area was getting wet from leaking coolant.

First Review:
Jan 14, 2022
After replacing with these clamps, I was able to stop the leak. The band is stainless steel, but the worm drive is a different color and does not look like its stainless steel. Hardly rains in my neck of the woods so not too worried about that part getting contact with moisture. How long it will stay rust free, only time will tell.

Helpful Hint: When I took the old clamp off and removed the hose, there was a lot of crud around the metal that the rubber hose goes over and inside the hose itself. Scraped and cleaned all that off and replaced with these. And no more leaks. Just in case, I used two clamps mounted in opposing directions to make sure I had good contact and proper seal.