We ordered the Double sliding barn door hardware last year and finally had them installed. According to our contractor it was easy to install, and all the parts were included. We turned a small closet into a half bath.

So the hardware is great and the company even better. Reach out to them and they help you get exactly what you need.

Here were my conundrums during installation:
First, I needed to use one of the hollow wall fasteners. It wasn't load baring but it was to keep the track from flopping around on the end. The hollow wall fasteners sent are for standard drywall. I was too cheap to buy standard drywall when I built the room so the fastener didn't work. A quick trip to the hardware store and I was back in business. All that to say, if you used thinner drywall, you will need different fasteners than those provided.

Next, and most importantly, the placement of the inner brackets on the doors. The pictures all show the brackets on the edges of the door. It looks amazing! However, if you actually place them there, the doors won't shut. The wheels stick out beyond the brackets and won't allow them to close. Don't make this mistake because drilling new holes aren't really an option. Pay attention to the wheels. I ended up correcting this mistake by purchasing HVAC pipe insulation tubes and putting those as buffers on the doors. Looks a little weird but not too bad. It did have a nice secondary affect in protecting the walls since I have an intentional 3" gap to the floor for airflow into the room.

Finally, the directions are quirky and a bit difficult to follow at first. Just know that if it has two measurements, the second one is from the first measurement, not the starting point.

Otherwise, great! Very smooth roll.

The instructions were pretty good, but one thing that puzzled us was the step where the round things were installed on the front/top of the doors. It keeps the door from jumping off the track. I don't think it mattered how far from the door hangers we put them. We put them about an inch inside the hangers on both sides. We have trim, so we had to build out the "header" so that it was flush with our existing trim so that the door wouldn't hit on the bolts on the wall side of the door. Our door is 1 3/4" thick. For the doors to close all the way, we had to put the door hanger/roller on the inside of the door trim. The thing you have to strongly consider is the depth off the wall if you have trim and that the hangers are placed such that the doors closes all the way. We didn't use the floor guide hardware that came with the kit because we don't have a router. I'm glad we didn't because it took so long for us to paint the door trim that the doors warped a little. We bought some that screw into the wall and you can adjust the base with different rollers. Make sure your wall is super flush and straight and I guess shim if necessary. Our wall bowed slightly on the right side and the rail is so rigid (for obvious reasons) that it scrapes a little on the right when we close the door. I think I will put an extra washer or two behind that one screw on the rail to straighten it out. We followed the directions precisely, and the height they said in the instructions worked out perfectly. It left about a half inch gap at the bottom of the door for air return when closed. The rail connector didn't hold it level, and wasn't as sturdy as I would have liked, so we didn't connect them until we had one side hung completely. We took our time and it took about 4 hours from start to finish.

We received this product on July 3, 2023 and my husband immediately started putting it together! We done the 10 foot track and absolutely loved it!

They are perfect! They are nice and heavy duty!