Arrived in only 11 days. Color match was dead on for our 2007 Lexus 350RX . It is applied over your original seat. Here are the directions; * Lay the new cover on the seat. Insert the chuck (large plastic piece, looking like a belt buckle) into the back seat gap. Pull this chuck rearward until it extends to the rear of the of the seat. (adjust the chuck so you can feel part of it halfway between the top and bottom of the gap.) The cover front is hooked to under the seat by the hooks. (Spend the time to find the best place to hook the front hooks.) Parentheses comments are mine and not the manufacturer for purpose of better understanding. Took all of 3 minuets. You will regret it if you do not order two. Update******. Not in the directions is a set of side to side fastening straps found only after the covers were moving and we removed them to better adjust them. They are Meant to go under the seat but ours worked better swinging around the sides and fasting in the rear.Now we get no movement at all. Working perfectly now. So there are three places to fasten ; front, sides and rear.

As soon as I installed the seat cover in my Elantra I realized I had made a mistake. I should have ordered one for the passenger seat also.
Had to wait for it to arrive. The look great and fit great

I purchased four driver seat covers for my 2017 ford explorer. Quality is good itself. The covers did not stay on the seats. The cover has a hook in front and a ring in back of middle, but it doesn't work. I had to purchased a band and another rings for back cover seats and connect hook and ring together to fit and stay on the seats. However, I am still figure it out that how to fix in front of two covers.

Great product and good quality for the money. I only purchased one to try it out and ended up purchasing a second one for the passenger side. It's not a perfect match to the gray color seat of my 2015 Subaru Forester, but near perfect IMO :)

I ended up ordering a matching back seat bench, which was listed separately on another page by the same seller. The fit on the backseat bench seats is not as perfect as the front covers, but pretty darn good and I'm glad I ordered the matching back seat cover too.

I ordered gray. I got taupe.

Since these things are literally mailed from China, I'm probably just going to live with it. Not worth the hassle of returning it. Still - annoying.

As far as installation, it has an elastic loop to go around the headrest support, a couple of plastic toggles that cram in the crack between the back and bottom of the seat, and a couple of little metal hooks to wrap under the bottom. The toggles worked but would be easier if the crack on the seats in my Toyota Tacoma wasn't sealed off at the back. There's absolutely nothing for the little hooks to catch on, but they don't seem all that necessary. It seems comfortable enough.