I needed to level and seal an OSB floor, this worked wonders but heavily soaked in. 1 bucket on old OSB did about 100sqft. Worth every penny.

Easy to mix and no odor!
Super shiny!
Super helpful company too. They answered any questions super quick!

COST FOR SUCH A QUALITY PRODUCT

I have been working with (deep pour) epoxy for many years & I was still very intimidated by this flooring project! I bought one kit for my small cabin & planned for months researching if it would be enough product, figuring out the pour technique, colors etc. I hope this review helps!

I purchased a second 3 gallon kit last minute before starting & so glad I did!

One of these kits is EXACTLY enough to cover 240sqft lol. But only ONE coat.

Mixing the first batch, I added a white epoxy dye & used a squeegee to spread the first layer...then started mixing the second batch while still wet. This first coat is necessary to do a dirty pour technique to help it blend & flow. The second, mixed batch, I divide into smaller buckets with different mica powder colors added. Dumped each color into a larger bucket and did a dirty pour. Turns out for a full, complete dirty pour, u need LOT of epoxy. I could have used a couple more kits tbh for that method. I ended up doing the dirty pour, but not with as much coverage as needed...so I just poured out everything I had, every last bit in all the buckets and colors...at this point it was very random and I was desperate to have the pigment & coverage. I then went over everything Again with a squeegee. I was worried I wouldn't get that faux stone/marble look u get with dirty pour...but it came out SO nice! Not too bad for my first try. I'm confident & obsessed to do this again!

If you have worked with epoxy u know that this stuff gets hot & will go off and cure in the bucket if you don't get it out & moving within 5-10 minutes. The kits directions on lid says to not leave in bucket for more than 5 minutes after mixing. This depends on the weather if it's 80 out I wouldn't delay. The large amount of mixed epoxy in bucket creates A LOT of heat!

Pour mixed batch into smaller buckets asap if u know you need more time. This smaller amount creates less heat.

Once you get it out on floor in a thin layer, you can work it for a good 20-30 minutes depending on weather/room temp. The product being more spread out & thin, creates less heat and you have time to work it with squeegee. If it's in direct sunlight or heat, forget about it...it will cure in minutes! Keep the a/c on if possible or work on cooler time of day. After you are done working...now u need the heat to cure this stuff. Wait at least 48 hrs before moving anything heavy onto floor

Have your colorings etc ready..any long delay can destroy your project.

Be sure to do a base color of paint on floor.

Mix thoroughly the most important part! Around 2.5-3 minutes until u don't see any ribbons of unmixed product.

Overall I'm super happy with this product & can't wait to do more! I transformed this run down, 1970s "jackrabbit homestead" from scary...to awesome. When I purchased this place it was full of birds nesting, broken roof & sad...now it's looking so luxurious!

The media could not be loaded. PLEASE GET EXTRA ..... So we thought 1 would be enough but it wasn't and we had to come back for another batch. From what we read we thought we were good of square footage but it just didn't cover like it was supposed to, after buying another 2 we went over the first and it turned out absolutely gorgeous 🥰 was completely dry in 24 hours .