Schieffer Co. B & S, Craftsman & Generac 1/4" X 30' Pressure Washer Hose - Made in USA
Key features
- •This Schieffer hose is Made in USA - Stamped on hose
- •Fits many Briggs & Stratton, DeVilbiss, Excell, Generac, Karcher & Ryobi Light duty units with dual 22mm-14 female
- •Briggs & Stratton # 196138GS, 6188. Generac # 6115. Devilbiss & Excell # 17781, D28094 & D22166
- •3,000 PSI working pressure
- •1/4" ID x 30' long - Ends: (2) 22mm Female twist conne
Schieffer Co. B & S, Craftsman & Generac 1/4" X 30' Pressure Washer Hose - Made in USA
List Price: $37.81$34.03DEALYou Save: $3.78 (10%)
Free shippingFree Returns – 30 daysFree Order CancellationSecure Payment2–3 Days DeliveryGet It June 23, 2026In Stock (2)No marketing spamNo account requiredFulfilment by FedEx / Amazon / UPS / ShipwirePayPal / Card Buyer Protection
Customer Reviews
Reviews sourced from verified Amazon purchasers4.3
out of 5
Based on 10 reviews
5★
70%
4★
10%
3★
10%
2★
10%
1★
0%
pressure washer replacement hose.
William S.•June 23, 2017
Perfect replacement. Both ends attached easily. Was a bit stiff at the start , but after several minutes in use it was flexible and
was easy to wrap and store on the washer.
was easy to wrap and store on the washer.
It looks just like the one that came off of it
JGP•November 10, 2016
I purchased this to replace a hose on a Troy Bilt 2,600 PSI pressure washer with a Honda engine I bought at Lowes. It looks just like the one that came off of it. I noticed the old one burst apparently because it had rubbed on too many rough surfaces about 4' from the pressure washer. I added a little protective duct tape to the new one.
Very Nice hose
ERIK•August 21, 2016
I used this to extend the 15' hose that came with my unit and so far no problems I like it This is rated for about 3000psi and my unit is electric 1600psi.
It fit like a glove, since I was extending I had to buy the hose to hose fitting.
It fit like a glove, since I was extending I had to buy the hose to hose fitting.
Three...THREE different spontaneous bursts. LOW LOW LOW quality
Anthony R. Calfo•August 18, 2016
Didn't like its quality and feel on arrival but hey...not asking it to do much. Plus I'm fastidious with my tools and workshop. Well...over a year later and I have repaired this hose in in THREE different places. I'm sorry, but I'm just adding this to the long list of reasons why I begrudgingly have to say that past/historic Craftsman quality is dead and gone. To think...I repaired TWO different spontaneous bursts and didn't complain or write a bad review. Three breaches takes the cake.
Far better than the tattered hose this replaced
Gary R•August 3, 2016
Far better than the tattered hose this replaced. However, I was hoping for something that wouldn't kink. This isn't that hose. Wish I had opted for a kink free hose even if it were more expensive.
Page 1 of 2
