Excellent Feeder that is strong, sturdy and quality. But, where do you get replacement parts? Fro example, one of the metal perch inserts had the metal post break. Can I buy a set of metal inserts somewhere?

Great bird feeder well made, sturdy and easy to clean! Got a good price on Amazon for 20" model but I was disappointed that they sent me the 16" model instead which is less expensive! I complained but the seller did nothing, so I am stuck with the 16" instead of 20" but it still a good feed that I would recommend.

Gone through a couple of different Yankee models. I like this one because it all comes apart for cleaning unlike the others.

Love this bird feeder! Love you can take apart to clean well and easily put back together.

This is the best bird feeder I have ever owned. I always use black oil sunflower seeds and after a while the dust and residue from the seeds builds up at the bottom of the tube and around the ports. This should really get cleaned out regularly as it is not healthy for the birds but I admit I used to neglect my old feeders as taking them apart was hard or impossible. About a year ago I found the Droll Yankees Onyx feeder. The Onyx has a removable base that twists off easily making it so much easier to get a brush into the tube to clean.
Two months ago I wanted to buy another Onyx feeder to replace one of my older tube feeders and found the Droll Yankees A-6RP Ring Pull Classic Sunflower Feeder. This one gets 5 stars and 2 thumbs up! To clean this you just open the top and pull the ring on the metal rod. The metal bottom and all the ports just fall away from the tube. There is a clear plastic insert at the bottom of the tube that just slides out and the top handle with the cap for the tube is also removable. It is the easiest to clean feeder that I have ever seen. Just run a brush with soapy water through the tube. You can soak and scrub the metal ports separately if needed. Rinse well and in seconds everything is clean.
It is very easy to reassemble too. You start by inserting the metal ports into the uppermost holes. Make sure you line up the perches with the small holes below the port. Hold the ports in place with one hand and insert the metal rod (ring pull) into the center hole of the cross bar at the top that holds the handle and slide the rod down until it is just below the metal ports . That holds the top ports in place and you can now repeat that on the mid ports. After the mid ports are secure, replace the plastic bottom, lining up the slots in the side with the small holes on the side of the tube near the bottom. Next insert the metal bottom piece, again lining up the holes. Then insert the bottom metal ports so that the perches are also lined up with those holes. Slide the rod to the bottom of the tube and everything should be secure. Replace the bail for the lid into the cross bar at the top and if everything is dry fill with seeds. Once you do this a time or two it literally takes only a minute or two to reassemble
This feeder cost a little bit more than most feeders, it is not cute or pretty, but I would recommend it to anyone who enjoys feeding birds. Cleaning it is so easy and the birds will appreciate eating there instead of at a feeder that is all gunked up.
The Droll Yankees Onyx feeder is great but this one is even better. I cannot think of a single thing I do not like about this feeder, and they are made in the USA!